VM13 VENTING MEMBRANES: lamps, ADAS, sensors, DC/DC converters: how are you protecting your electronic housings?

In automotive electronics, every housing breathes — rear lamps, foglamp modules, ADAS sensors, DC/DC converters. As temperature rises, internal pressure builds up. Without a properly managed release, this pressure stresses seals, promotes condensation, and ultimately compromises component reliability over time.

That’s where the GERGOVENT VM13 comes in! Our proven ePTFE adhesive venting membranes, already used across these applications for years.

Close-up on the VM13 solution

The VM13 is a black ePTFE adhesive membrane engineered to equalize pressure while blocking water, dust, and contaminants. It’s applied by simple adhesive bonding — no drilling, no mechanical insert required — a genuine time saver on the production line.

Key technical benefits

On top of that, the VM13 delivers proven performance where it really counts:

airflow above 250 ml/min/cm² at 70 mbar
water intrusion resistance ≥ 1 bar,
-40°C to +150°C operating range
PFOA-free compliance

Discover the VM13 data sheet

For Further information about ePTFE adhesive venting membranes, please contact our sales team!